lab

Hit Starter With Hammer

Hit Starter With Hammer. Buy a new starter it is worth not having the trouble. My dad has been doing this for quite some time.when a starter is going out, you can usually tap it with a hammer and if it works then you know the starting issue is definatly the starter going bad.

1995 Ford Taurus starter. Managed to get both bolts out, had to remove from www.reddit.com

You can sometimes activate your starter by striking it gently with a hammer on the side. Be sure not to hit the solenoid or anything plastic and don't hit it too hard. (you can’t do it again & again).

Hitting It With A Hammer Breaks It Loose So It Will Engage To Turn The Car Over.

Gently hit it against the side of the starter, and the engine will start. Be sure not to hit the solenoid or anything plastic and don't hit it too hard. Yes, you can hit your starter with a hammer.

Gotpasswords October 30, 2009, 11:42Pm #5.

Can you hit your starter with a hammer? If it starts, the starter was 'frozen' and should be replaced. Push the handbrake lever down and rock the vehicle a little.

When You Hit With A Hammer, It Moves And Lets The Starter Work Again.

You can sometimes activate your starter by striking it gently with a hammer on the side. Most likely, a bad solenoid. The signs of a bad starter include:

I Doubt Tapping On The Starter Will Help In This Situation.

Ideal would be over 12.6 volts, if less than 12.2 volts, recharge battery. Hit it on the side housing where it's solid. Whilst starting the car, hit the starter (not hard enough to dent it) with the hammer.

It May Help You Find A Poor Connection.

Be careful of the electrical connections. My dad has been doing this for quite some time.when a starter is going out, you can usually tap it with a hammer and if it works then you know the starting issue is definatly the starter going bad. 3 people found this helpful.

Leave a Reply

Your email address will not be published.